DPF cleaner concentrated IBS

Water-based professional cleaning concentrate for exhaust aftertreatment systems and selected mechanical components
Designed for use in common cleaning machines and diluted with water at a concentration of 3–10% depending on the degree of contamination
The low-foaming formulation contains corrosion protection for material-friendly cleaning.
Type: alkaline, aqueous high-performance cleaning concentrate
Application concentration: 3–10%
pH value: <11
Color: blue
Density: 1.05–1.07 g/cm³
Foaming behavior: non-foaming / low-foaming
Oduor: characteristic
CLP labelling: none required
Suitable for: Diesel particulate filters (DPF); FAP filters; SCR systems; Catalytic converters
Also suitable for selected mechanical components such as: Oil filters; Pistons; Injection nozzles; Tools
Removes: Soot; Ash deposits; Carbon deposits and coking; Oil carbon and graphite; Grease and oil contamination
Benefits: Low-foaming formulation for reliable machine use; Integrated corrosion protection for material-friendly cleaning; Demulsifying and suitable for use with oil separators; Labelling-free according to the CLP Regulation

Recommended concentration for 10 L of ready-to-use cleaning solution:
3% = 0.3 L concentrate + 9.7 L water
5% = 0.5 L concentrate + 9.5 L water
10% = 1.0 L concentrate + 9.0 L water
Start with the lowest suitable concentration and increase the dosage only when required by the degree of contamination

Cleaning instructions:
1. Remove the filter or component according to the vehicle or equipment manufacturer’s instructions
2. Dilute the concentrate with water according to the degree of contamination
3. Fill the cleaning machine with the prepared solution and position the component according to the machine manufacturer’s instructions
4. Run the cleaning cycle using the operating time, temperature and procedure specified by the machine manufacturer
5. For heavily contaminated components, increase the concentration within the recommended 3–10% range or repeat the cleaning cycle if necessary
6. After cleaning, complete the rinsing and drying procedure specified by the machine manufacturer
7. Ensure the component is completely ready for installation before refitting