Cutter for laminate floor planks

Guillotine for cutting floor and wall laminated panels. Made of thick sheet steel. The design is exceptionally rigid and resistant to deformation caused by strong pressure on the long arm. This guarantees ease and accuracy of cutting.
The maximum cutting width is 210 mm. This allows you to cut most commercially available panels with a typical width of 130, 150, 160 and 190 mm.

Stable 100 mm wide table, supported on legs with rubber washers and holes for permanent fastening.
The length of the large arm is about 520 mm. Reduces the pressure force and facilitates cutting
The guillotine lever is equipped with a high rubber stopper that protects the palm from accidental compression.
The blade with a special protective profile, cuts panels up to 12 mm thick.
Additional support for the horizontal support when cutting long panels.

Length: 710 mm
Material: galvanized sheet steel
Designed for cutting laminated panels
Surface finish: powder coated
Dimensions max.: Width 210. max. Thickness 12 mm
Weight: 5.75 kg